Avaya C460 - Manual (Page 61)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 49
To restore the maximum number of ARP cache entries to its default:
ip max-route-entries
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
The ip max-route-entries command exists for compatibility with Avaya™
P580. There is no limitation on the size of the routing table, except for the amount of
available memory.
Use the no ip max-route-entries command to remove the limitation.
The syntax for this command is:
[no] ip max-route-entries <value>
Example:
ip netbios-rebroadcast
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the ip netbios-rebroadcast command to set the NETBIOS rebroadcasts
mode on an interface.
Use the no ip netbios-rebroadcast command to disable NETBIOS
rebroadcasts on an interface.
The syntax for this command is:
[no] ip netbios-rebroadcast <mode>
C460-1(configure)# no ip max-arp-entries
value number of entries
C460-1(configure)# ip max-route-entries 4000