Avaya C460 - Manual (Page 224)

Chapter 2 Avaya C460 CLI Commands
212 Avaya C460 Reference Guide
show snmp retries
User level: read-only, read-write, admin.
Use the show snmp retries command to display the number of retries initiated
by the C460 Manager when it tries to send SNMP messages to the device.
The syntax for this command is:
show snmp retries
Example:
show snmp timeout
User level: read-only, read-write, admin.
Use the show snmp timeout command to display the default SNMP timeout in
seconds.
L This command is useful for access using the Device Manager.
The syntax for this command is:
show snmp timeout
Example:
show spantree
User level: read-only, read-write, admin.
Use then show spantree command to display spanning-tree information.
The syntax for this command is:
show spantree [<module>[/<port>]]
C460-1> show snmp retries
the SNMP Retries Number is 3
C460-1> show snmp timeout
the SNMP Timeout is 2000
module
(Optional) Number of the module. If you do not specify a number, all
modules are shown.
port
(Optional) Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4