Show timezone, Show trunk, Show timezone show trunk – Avaya C460 User Manual
Page 233
Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide
221
show timezone
User level: read-only, read-write, admin.
Use the show timezone command to display the current C460 time zone.
The syntax for this command is:
show timezone
Example:
show trunk
User level: read-only, read-write, admin.
Use the show trunk command to display VLAN tagging information for the
switch.
The syntax for this command is:
show trunk
[<module>[/<port>-<port]]
Example:
Output Fields:
C460-1> show timezone
Timezone set to 'GMT', offset from UTC is 0 hours
module
(Optional)
Number of the module. If you do not specify a number, all
modules are shown.
port
(Optional)
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4
C460-1> show trunk 4/1
Port
Mode
Binding mode
Native vlan
-----
-----
--------------------
-----------
41/1 off statically bound 1
41/2
dot1q
statically bound
2
Field
Description
Port
Switch and port number(s)