Avaya C460 - Manual (Page 90)

Chapter 2 Avaya C460 CLI Commands
78 Avaya C460 Reference Guide
application.
Use the no rmon2 protocol-dist command to disable the application.
The syntax for this command is:
[no] rmon2 protocol-dist
Example:
router ospf
User level: read-write, admin.
Use the router ospf command to enable the OSPF protocol on the system.
Use the no router ospf command to disable the OSPF one the system.
The default is disabled.
The syntax for this command is:
[no] router ospf
Example:
router rip
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the router rip command to configure the Routing Information Protocol
(RIP). Use the no router rip command to disable RIP.
The default state is disabled.
The syntax for this command is:
[no] router rip
Example:
Router-1# rmon2 protocol-dist
Done!
Router-1 (super) # router ospf
Done!