Avaya C460 - Manual (Page 125)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 113
Example:
set port powerinline
User level: read-write, admin.
Use the set port powerinline command to enable or disable the load detection
process on the port.
The syntax for this command is:
set port powerinline <module_number/port_number> {enable |
disable}
Example:
To enable PoE on ports 1 to 3 of module three:
set port powerinline priority
User level: read-write, admin.
Use the set port powerinline priority command to set the priority level
for powering the port.
The syntax for this command is:
set port powerinline <module_number/port_number> <priority>
C460-1# set port point-to-point admin status 1/1 force-true
port 1/1 point to point admin status is set to force-true
module Number of the module (3-6).
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
enable Enable load detection on the port
disable Disable load detection on the port
C460-1# set port powerinline 3/1-3 enable
Load detection process on ports 3/1-3 is enabled
module Number of the module (3-6).