Avaya C460 - Manual (Page 238)

Chapter 2 Avaya C460 CLI Commands
226 Avaya C460 Reference Guide
L You can only access these commands in the Router-RIP context.
Type router rip at the command prompt to enter the Router-RIP context if
necessary.
Use the timers basic command to configure the route timer.
Use the no timers basic command to restore the timers to their default values.
Example:
The syntax for this command is:
timers basic <update><invalid>
L The Invalid Route Timer value must be larger than the Update Timer value. It is
recommended that it be at least three times greater.
In any configuration all adjacent routers must have the same values for each of
the timer parameters. It is possible to have different values for the timers on two
adjacent routers, provided the Invalid Timer value is at least three times greater
on one of the routers than the Update Timer value on the other router.
Example:
Use the timers basic command to configure the route timer.
Use the no timers basic command to restore the timers to their default values.
The syntax for this command is:
timers basic <update><invalid>
Router-N(configure router:rip)# timers basic 30 180
update RIP update timer in seconds (minimum = 30;
default = 30)
invalid RIP invalid route timer in seconds (minimum =30;
default = 180)
Router-N(configure router:rip)# timers basic 30 180
update RIP update timer in seconds (minimum = 30;
default = 30)