Avaya C460 - Manual (Page 138)

Chapter 2 Avaya C460 CLI Commands
126 Avaya C460 Reference Guide
Example:
set radius authentication udp-port
User level: read-write, admin.
Sets the RFC 2138-approved UDP port number.
Normally, the UDP port number should be set to its default value of 1812. Some
early implementations of the RADIUS server used port number 1645.
The syntax for this command is:
set radius authentication udp-port <number>
Example:
set slot power admin
User level: read-write, admin.
Use the set slot power command to power up or power down a slot. If there is
a module in the slot, then the command will reset the device.
The syntax for this command is:
set slot power admin <slot> <status>
secondary Secondary authentication server
C460-1(super)# set radius authentication server
192.40.12.36 primary
C460-1(super)# set radius authentication udp-port number
1645
Slot Slot number
Status • Up – power up the module
• Down – power down the nodule