Avaya C460 - Manual (Page 52)

Chapter 2 Avaya C460 CLI Commands
40 Avaya C460 Reference Guide
Example:
ip access-list-dscp name
User level: read-write, admin.
L If you are at the ”read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the ip access-list-dscp name command to set a name for a dscp entry.
The syntax for this command is:
ip access-list-dscp name <policy-list-number> <dscp> <name>
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
ip access-list-dscp operation
User level: read-write, admin.
L If you are at the ”read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the ip access-list-dscp operation command to set a DSCP to CoS
mapping.
L The C460 performs the mapping for only those frames than match an ACL rule
with a “permit” action.
The syntax for this command is:
ip access-list-dscp operation <policy-list-number> <dscp>
C460-1(configure)# ip access-list-copy 100 101
<policy-list-number> integer (100 to 149)
dscp DSCP entry (0 to 63)
<name> entry name
C460-1(configure)# ip access-list-name 101 16 special