Avaya C460 - Manual (Page 96)

Chapter 2 Avaya C460 CLI Commands
84 Avaya C460 Reference Guide
set device-mode (Layer 3)
User level: read-write, admin.
Use the set device-mode command to change the basic mode of operation of the
C460 switch between Router and Layer 2 modes.
The syntax for this command is:
set device-mode <mode>
Example:
set dot1x max-req
User level: supervisor
Use the set dot1x max-req command to set maximum number of times the port
tries to retransmit requests to the Authenticated Station before the session is
terminated.
The syntax for this command is:
set dot1x max-req <count>
Example:
set dot1x quiet-period
User level: supervisor
Use the set dot1x quiet-period command to set the minimal time between
authentication attempts.
The syntax for this command is:
set dot1x quiet-period <Seconds>
mode Router | Layer2
Router-1> set device-mode Layer2
This command will RESET the device
*** Reset *** - do you want to continue (Y/N)? y
count Number of attempts (1 to 10)
C460-1(super)# set dot1x max-req 3
Seconds Number of seconds – 0 to 65535