Avaya C460 - Manual (Page 40)

Chapter 2 Avaya C460 CLI Commands
28 Avaya C460 Reference Guide
The syntax for this command is:
copy tftp l2-config <filename> <ip>
Example:
copy tftp startup-config
User level: read-write, admin.
Use the copy tftp startup-config command to copy the C460 configuration
from the saved TFTP file to the Startup Configuration NVRAM.
The syntax for this command is:
copy tftp startup-config <filename> <ip>
Example:
copy tftp SW_imageA
User level: read-write, admin.
Use the copy tftp SW_imageA command to update the software image in Bank
A of all the Supervisor Modules installed in the switch.
L To use this command, you need to have an active tftp server and to create a file
into which to download the data.
L If Avaya MultiService Network Manager is running, you do not require an
filename file name (including full path)
ip IP address of the host
C460-1# copy tftp l2-config c:\C460\backup 149.49.152.36
Beginning download operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
*********************************************************************
* If you are currently running the C460 Device Manager application, *
* it is recommended to exit from it before performing configuration *
* download operations. *
*********************************************************************
filename file name (full path)
ip The ip address of the host
Router-1> copy tftp startup-config c:\C460\router1.cfg
192.168.49.10