Avaya C460 - Manual (Page 206)

Chapter 2 Avaya C460 CLI Commands
194 Avaya C460 Reference Guide
show port edge state
User level: read-only, read-write, admin.
Use the show port edge state command to show a port’s edge admin and
operational RSTP state.
L A port can be set to admin state of edge port, but if a BPDU is received on this
port the oper state is changed to non-edge state.
The syntax for this command is:
show port edge state <module/port>
Example:
show port flowcontrol
User level: read-only, read-write, admin.
Use the show port flowcontrol command to display per-port status
information related to flow control.
The syntax for this command is:
show port flowcontrol [<module>[/<port>]]
module Number of the module (3-6). If you do not specify a number, the
ports on all the modules are shown.
port
(Optional) Number of the port on the module. If you do not specify a number,
all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
C460-1> show port edge state
Port admin state oper state
------- ------------- -------------
1/1 edge-port edge-port
1/2 non-edge-port non-edge-port
module
(Optional) Number of the module (3-6). If you do not specify a number, all
modules are shown.
port
(Optional) Number of the port on the module. If you do not specify a
number, all ports on the specified module are shown.