Avaya C460 - Manual (Page 55)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 43
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
ip access-list-owner
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip access-list-owner command to set the owner for a specific policy
list.
The syntax for this command is:
ip access-list-owner <policy-list-number> <owner>
Example:
ip address
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the ip address command to assign an IP address and mask to an interface.
The syntax for this command is:
ip address <ip-address> <mask> [<admin-state>]
<name> list name
C460-1(configure)# ip access-list-name 101 morning
<policy-list-number> integer (100 to 149)
<owner> list owner
Router-1> ip access-list-owner 101 admin
Done!
ip address The IP address assigned to the interface.