Avaya C460 - Manual (Page 65)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 53
Example:
ip ospf priority
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip ospf priority command to configure interface priority used in DR
election.
Use the no ip ospf priority to set the OSPF priority to its default value.
The default is 1.
The syntax for this command is:
[no] ip ospf priority <priority>
Example:
ip ospf router-id
User level: read-write, admin.
L You can only access this command in Router-OSPF mode.
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
Use the ip ospf router-id command to configure the router identity.
Use the no ip ospf router-id command to return the router identity to its
default (lowest IP interface that exists).
The syntax for this command is:
[no] ip ospf router-id <router id>
Router-1(configure-if:marketing) # ip ospf hello-interval 5
Done!
priority integer
Router-1(configure-if:marketing) # ip ospf priority 17
Done!
router id IP address