Avaya C460 - Manual (Page 83)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 71
ping
User level: read-only, read-write, admin.
Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping [host]
Example: to ping the IP number 149.49.48.1:
ping (Layer 3)
User level: user, privileged, supervisor
Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping <host> [<interval> [<size> [<timeout> [<source
address>]]]]]
host Host IP address/Internet address of route destination.
If you do not specify a host IP, then the last host IP is used.
C460-1> ping 149.49.48.1
149.49.48.1 is alive
host Host IP address/Internet address of route destination. If missing
then the last host IP is used.
interval Interval between ping commands in seconds (1 to 256)
size Size of packet in bytes (22 to 66500)
timeout Timeout in seconds (1 to 10)
source
address IP address of one of the router interfaces