Avaya C460 - Manual (Page 236)

Chapter 2 Avaya C460 CLI Commands
224 Avaya C460 Reference Guide
sync spv
User level: read-write, admin.
Use the sync spv command to synchronize the following between an Active
Supervisor Module and Halted Supervisor Module:
•
Boot bank
• Firmware images
• Device manager image
L You can only execute this command from the active Supervisor Module CLI.
The syntax for this command is:
sync spv
The synchronization may take up to 90 seconds to complete.
Example:
L The configuration is synchronized after you perform a reset.
tech
Use the tech command to enter tech mode. This command is reserved for service
personnel use only.
C460-1(super)# sync spv
This command may overwrite the neighbor SPV software and
reset it
*** Confirmation *** - do you want to continue (Y/N)? y
Copying Bank A to the neighbor SPV ...
Copying Bank A to the neighbor SPV done
Copying Bank B to the neighbor SPV ...
Copying Bank B to the neighbor SPV done
Copying Embedded Web image to the neighbor SPV ...
Copying Embedded Web image to the neighbor SPV done
Setting boot bank of the neighbor SPV ...
Setting boot bank of the neighbor SPV done
Setting chassis sync on for the neighbor SPV...
Setting chassis sync on for the neighbor SPV done
SPVs are resetting.
Please wait till the process is finished. The SPVs will be
synchronized after the reset is completed