Avaya C460 - Manual (Page 82)

Chapter 2 Avaya C460 CLI Commands
70 Avaya C460 Reference Guide
nvram initialize {switch | all}
Example:
L The nvram initialize command does not alter the Active/Standby status of the
Supervisor modules.
passive-interface
User level: read-write, admin.
L You can only access this command in Router-OSPF mode.
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
Use the passive interface command to allow interfaces to be flooded into the
OSPF domain as OSPF routes and not external routes.
Use the no passive interface command to disble the flooding.
L An interface becomes passive only if you use the network command to enable
OSPF to run on the interface.
The syntax for this command is:
passive-interface <interface-name/net addr>
Example:
switch Resets all the switch information (Layer 2 only).
all Resets all parameters including routing parameters in the
switch.
C460-1# nvram initialize
This command will restore factory defaults, and can
disconnect your telnet session
*** Reset *** - do you want to continue (Y/N)? y
Connection closed by foreign host
interface-name /
net addr Name of interface or IP address.
Router-1# passive-interface FastEthernet 1.10