Avaya C460 - Manual (Page 62)

Chapter 2 Avaya C460 CLI Commands
50 Avaya C460 Reference Guide
The possible values of mode are:
Example:
To enable rebroadcasting of netbios packets received by and sent from the interface
“marketing”:
ip netmask-format
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip netmask-format command to specify the format of netmasks in the
show
command output.
Use the no ip netmask-format command to restores the default format which is
a dotted decimal.
The syntax for this command is:
[no] ip netmask-format <mask-format>
The possible mask formats are:
both Netbios packets received on the interface
rebroadcasted to other interfaces and netbios packets
received on other interfaces are rebroadcasted into
this interface.
disable Netbios packets are not rebroadcasted into or out of
this interface.
Router-1(config-if:marketing)# ip netbios-rebroadcast both
bitcount Addresses are followed by a slash and the total number of bits
in the netmask. For example 17
decimal The network masks are in dotted decimal notation. For
example, 255.255.255.0.
hexadecimal The network masks are in hexadecimal format as indicated by
the leading 0X. For example, 0XFFFFFF00.