Avaya C460 - Manual (Page 92)

Chapter 2 Avaya C460 CLI Commands
80 Avaya C460 Reference Guide
Example:
L The security level stays the same when you use the session command.
set allowed managers
User level: read-write, admin.
Use the set allowed managers command to enables or disable the Allowed
Managers feature.
When this feature is enabled, only those stations whose IP addresses are listed in the
Allowed Managers table can access the device over Telnet, SNMP, or HTTP.
The syntax for this command is:
set allowed managers [enabled|disabled]
Example:
set allowed managers ip
User level: read-write, admin.
Use the set allowed manager ip command to add or remove an IP address
from the Allowed Managers table. The Allowed Managers table can contain up to
twenty IP addresses.
The syntax for this command is:
set allowed managers ip [add | delete][IP address]
C460-1> session router
Router-1 (super) #
C460-1(super)# set allowed managers enabled
Managers are enabled
add Add specified IP address to the Allowed Managers
table
delete Deletes specified IP address from the Allowed
Managers table
IP address IP address to be added or remove