Avaya C460 - Manual (Page 76)

Chapter 2 Avaya C460 CLI Commands
64 Avaya C460 Reference Guide
The syntax for this command is:
[no] ip vrrp <vr-id> override addr owner
Example:
ip vrrp preempt
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip vrrp preempt command to configure the router to preempt a lower
priority master for the virtual router ID.
Use the no ip vrrp preempt command to disable preemption for the virtual
router instance.
By default, preemption is enabled.
The syntax for this command is:
[no] ip vrrp <vr-id> preempt
Example:
ip vrrp primary
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip vrrp primary command to set the primary address that shall be
used as the source address of VRRP packets for the virtual router ID.
Use the no ip vrrp primary command to return to the default primary address
vr-id Virtual Router ID (1-255)
Router-1(configure-if:marketing) # ip vrrp 1 override addr
owner
Done!
vr-id Virtual Router ID (1-255)
Router-1(configure-if:marketing) # ip vrrp 1 preempt
Done!