Avaya C460 - Manual (Page 145)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 133
The syntax for this command is:
set spantree max-age <seconds>
Example:
set spantree priority
User level: read-write, admin.
Use the set spantree priority command to set the bridge priority for STP.
The syntax for this command is:
set spantree priority <bridge_priority>
Example:
set spantree tx-hold-count
User level: read-write, admin.
Use the set spantree tx-hold-count command to limit the maximum
number of BPDUs transmitted during a hello-time period.
The syntax for this command is:
set spantree tx-hold-count <rate>
max-age The max age time in seconds to keep message information before it is
discarded. Value ranges between 6 to 40; value must be between 2 X
(Bridge-Hello-Time + 1) and 2 X (Bridge-Forward-Delay - 1).
Recommended value is 20 sec.
C460-1# set spantree max-age 20
bridge max age is set to 20.
bridge_priority Number representing the priority of the bridge with a priority
level from 0 to 65535.
0 indicates high priority and 65535 indicates low priority.
C460-1# set spantree priority 4096
Bridge priority set to 4096.
rate Value between 1 to 10; recommended value is 3