Lenze E84DGFCR - Manual (Page 29)

EDS84DMOTPNET EN 2.0 - 11/2011
L
29
Communication manual 8400 motec PROFINET
Commissioning
Setting the station name
In the »Engineer« the station name is set under the Settings tab.
 Then click Accept change. The station name is saved and written to code C13899 .
 In the Lenze setting a deleted name is displayed. The name is also deleted if the "Reset
to factory defaults" command is executed by an IO supervisor or an I/O controller.

How to activate changed settings in the »Engineer«:
1. Execute device command C00002 = "11: Save all parameter sets".
2. Carry out a "reset node" of the node, or switch the voltage supply of the
communication module off and on again