Lenze E84DGFCR User Manual
Page 32
Communication manual 8400 motec PROFINET
Commissioning
Setting the IP configuration
32
L
EDS84DMOTPNET EN 2.0 - 11/2011
2. By double-clicking on the individual IP parameters, you can set the IP configuration
for each PROFINET node in the Configure nodes dialog window.
3. Click Transferred.
• The IP configuration is transferred to the corresponding PROFINET node.
• Changes in the IP parameters will become effective immediately.
• The IP parameters are written to codes
(subnet
mask), and
(gateway address) of the Communication Unit.
Tip!
By clicking the Find device button in the Assign IP addresses dialog window (see
step 1), you can check whether the configuration was transferred successfully.
With device command C00002 = "11: Save all parameter sets", the current IP
configuration is saved non-volatilely in the memory module.