Lenze E84DGFCR - Manual (Page 74)

Communication manual 8400 motec PROFINET
Parameter reference
Parameters relevant for PROFINET communication
74
L
EDS84DMOTPNET EN 2.0 - 11/2011
13.2 Parameters relevant for PROFINET communication
This chapter lists the PROFINET parameters of the Communication Unit in numerically
ascending order.
C13000
C13001

Note!
PROFINET command "Reset to factory defaults"
If the "Reset to factory defaults" PROFINET command is executed by an IO
supervisor or an I/O controller, the PROFINET-specific parameters will be reset to
their standard values:
•
C13000 | IP address
• C13001 | Subnetwork mask
• C13002 | Gateway address
• C13010 | Active IP address
• C13011 | Active subnetwork mask
• C13012 | Active gateway address
• C13864 | Active station name
• C13887 | Suppress signalling diag. mess. upon
• C13899 | Station name
• C13910 | I&M1 system designation
• C13911 | I&M1 installation site
• C13912 | I&M2 installation date
• C13913 | I&M3 additional information
• C13914 | I&M4 signature code
Parameter | Name:
C13000 | IP address
Data type: UNSIGNED_32
Index: 11575
d
= 2D37
h
Setting of the IP address
 Setting the IP configuration ( 30)
Setting range (min. value | unit | max. value) Lenze setting
0 4294967295 0
; Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C13001 | Subnetwork mask
Data type: UNSIGNED_32
Index: 11574
d
= 2D36
h
Setting of the subnet mask
 Setting the IP configuration ( 30)
Setting range (min. value | unit | max. value) Lenze setting
0 4294967295 0
; Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT