Lenze E84DGFCR - Manual (Page 87)

EDS84DMOTPNET EN 2.0 - 11/2011
L
87
Communication manual 8400 motec PROFINET
Index
14 Index
A
Accessing process data 39
Active gateway address (C13012) 76
Active IP address (C13010) 75
Active station name (C13864) 79
Active subnetwork mask (C13011) 76
Acyclic channel (PROFIdrive profile) 45
Acyclic data transfer 46
Acyclic data transmission process 46
All words from drive to master (C13850) 76
All words from master to drive (C13851) 77
Application as directed 13
Application notes (representation) 10
Application of the Communication Unit 13
Approvals 17
B
Baud rate 17
Before initial switch-on 26
Bus counter (C13862) 78
Bus error(1) (C13877) 80
Bus error(2) (C13878) 80
Bus state (C13861) 78
C
C01501 | Resp. to communication error with MCI 73
C01503 | MCI timeout 73
C13000 | IP address 74
C13001 | Subnetwork mask 74
C13002 | Gateway address 75
C13003 | Physical address 75
C13010 | Active IP address 75
C13011 | Active subnetwork mask 76
C13012 | Active gateway address 76
C13850 | All words from drive to master 76
C13851 | All words from master to drive 77
C13860 | Settings 77
C13861 | Bus state 78
C13862 | Bus counter 78
C13864 | Active station name 79
C13867 | Display: Most recent diagnostic data 79
C13877 | Bus error(1) 80
C13878 | Bus error(2) 80
C13880 | Reaction on communication failure 81
C13881 | Reaction time delay 81
C13885 | Clear process data 81
C13887 | Suppress signalling diag. mess. upon 82
C13899 | Station name 82
C13900 | Firmware product type 82
C13901 | Firmware compilation date 83
C13902 | Firmware version 83
C13910 | I&M1 system designation 83
C13911 | I&M1 installation site 83
C13912 | I&M2 installation date 83
C13913 | I&M3 additional information 83
C13914 | I&M4 signature code 84
Cable length 17
Carry out the port interconnection in the »Engineer«
40
Clear process data (C13885) 81
Codes 73
Commissioning 26
Communication channels 38
Communication medium 17
Communication profile 17
Communication time 18
Communication-relevant parameters of the operating
system 73
Configuration for device control 27
Configuring consistent data 61
Configuring the IO controller 27
Conformities 17
Connection establishment of an I/O controller to an I/
O device 45
Connections 15
Consistent parameter data 61
Conventions 8
Conventions used 8
Copyright 2
D
Data communication with consistency 61
Data transfer 38
Data transmission (process) 46
Decimal representation of the IP parameters 33
Device- and application-specific safety instructions 12
Device data base file 27
Device description file 27
Device ID 17
Device identification 17
Device protection 12
Diagnostic data 67
Diagnostic messages 67
Diagnostics 64
Diagnostics with the »Engineer« 66
Display
Most recent diagnostic data (C13867) 79
Document history 7