Lenze E84DGFCR - Manual (Page 9)

EDS84DMOTPNET EN 2.0 - 11/2011
L
9
Communication manual 8400 motec PROFINET
About this documentation
Terminology used
1.3 Terminology used
Term Meaning
Controller Lenze frequency inverter of the "Inverter Drives 8400 motec" product series
Standard device
Drive Unit
Communication Unit
Wiring Unit
The controller 8400 motec consists of the following modules: "Drive Unit",
"Communication Unit" and "Wiring Unit".
• The Drive Unit is available in various power classes.
• The Communication Unit is available in the following versions:
–No fieldbus
–AS-i option
–CANopen option
–PROFIBUS option
–PROFINET option
–EtherCAT option
• The Wiring Unit provides flexible connection options for an easy integration
into the power supply of the machine.
»Engineer« PC software from Lenze which supports you in "engineering" (parameter setting,
diagnosing, and configuring) during the entire life cycle, i.e. from planning to
maintenance of the commissioned machine.
Code Parameter which serves to parameterise and monitor the controller. In normal
usage, the term is usually referred to as "Index".
Subcode If a code contains several parameters they are stored in so-called "subcodes".
In the documentation the forward slash "/" is used as a separator between the
designation of the code and the subcode (e.g. "C00118/3").
In normal usage, the term is also referred to as "Subindex".
Lenze setting These are settings with which the device is preconfigured ex works.
Basic setting
HW
Hardware
SW Software
I/O controller PROFINET master
The I/O controller takes over the master function for data communication of the
decentralised field devices. The I/O controller usually is the communication
interface of a PLC.
I/O device PROFINET slave
IO supervisor Engineering and diagnostics tools
The IO supervisor can access process data, diagnostic data, and alarm data.