Lenze EDB9300UES - Manual (Page 135)

Operation and Software
130 BA8230
Or control Tn
1)
Parameter for adjusting the recovery time of the flux orientation control. This
parameter is set automatically according to the motor data entered but can be
overwritten if required.
A change on the “Type data” menu will initialise the parameter, i.e. the values input
are replaced.
Range: 0 ... 10 000 s
As supplied: (Calculated according to the type data)
1)
Only accessible on protection level 1 and above.
Flux control Kp
1)
Parameter for setting the P gain of the flux control. This parameter is set automatically
according to the motor data entered but can be overwritten if required.
A change on the “Type data” menu will initialise the parameter, i.e. the values entered
are replaced.
Range: 0 ... 100 000
As supplied: 4
1)
Only accessible on protection level 1 and above.
Flux control Tn
1)
Parameter for setting the flux control recovery time. This parameter is set
automatically according to the motor data entered but can be overwritten if required.
A change on the “Type data” menu will initialise the parameter, i.e. values entered are
replaced.
Range: 0 ... 10 000 s
As supplied: (Calculated according to the type data)
1)
Only accessible on protection level 1 and above.
Show/Hide Bookmarks