Lenze E82MVxxx 2Bxxx - Manual (Page 118)

Commissioning
Important controller codes
7
l
118 EDK82MV371 DE/EN/FR 7.0
Code Possible settings IMPORTANT
No. Name Lenze Selection
C0002
*
s
uSEr
Parameter
set
managemen
t 0 0 Ready PAR1 ... PAR4:
l Parameter sets of the
controller
l PAR1 ... PAR4 also
contain the
parameters for the
function modules
standard I/O,
application I/O, AS
interface, system bus
(CAN)
FPAR1:
l Module−specific
parameter set of the
fieldbus function
modules INTERBUS,
PROFIBUS−DP,
LECOM−B,
DeviceNet/CANopen
l FPAR1 is saved in the
function module
Restoring
the delivery
status 1 Lenze setting ð PAR1 Restore the delivery
status in the parameter
set selected
2 Lenze setting ð PAR2
3 Lenze setting ð PAR3
4 Lenze setting ð PAR4
31 Lenze setting ð FPAR1 Restore the delivery
status in the fieldbus
function module
61 Lenze setting ð PAR1 + FPAR1 Restore the delivery
status in the selected
parameter set of the
controller and in the
fieldbus function module
62 Lenze setting ð PAR2 + FPAR1
63 Lenze setting ð PAR3 + FPAR1
64 Lenze setting ð PAR4 + FPAR1
C0002
*
s
uSEr
(Contin
uation)
Transferring
parameter
sets with the
keypad By means of the keypad
you can transfer the
parameter sets to other
controllers.
During the transmission
the access to the
parameters via other
channels is inhibited!
Keypad ð controller Overwrite all available
parameter sets
(PAR1 ... PAR4, if required
FPAR1) with the
corresponding data of
the keypad
70 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet, CANopen
10 with all other function modules