Lenze E82MVxxx 2Bxxx - Manual (Page 71)

l
71 EDK82MV371 DE/EN/FR 7.0
Commissioning of 8200 motec without function module
l The 8200 motec can only be used when the FIF
cover
0 is mounted! (delivery status).
– If the FIF cover is not mounted, the 8200 motec
is inhibited (keypad:
dc
).
l Since the 8200 motec without a function module
does not provide any control terminals, starting and
stopping during operation is also possible by
switching the mains.
l The
j
function saves the setpoint at the time the
operation is interrupted when switching the mains
or in case of mains failures. The drive restarts
automatically as soon as the mains recovers!
l If the drive does not start at step
ƒ
(
c
is not off),
press
U
to enable the 8200 motec.
8200mot041
A
8200mot042
L1 / L2 / L3 / N / PE
W2 U2 V2
U
PE
1 V1 W1
w j
y
0....- 50 Hz
z
0....+50 Hz
z
y
w x
v
t
u
s
5000
c d
j
Hz
0140
3 1 2
AIF
z
y
w x
v
t
u
s
88888 8888 888 8 a b c d e jg fk ih PS  ‚m no p q r Hi Hz %sh rpm °C Ω
m A V Lo
E82ZBB
E82ZWLxxx
Step Comment
 Connect diagnosis terminal
(contains keypad) with motec.
Put the plug of the
connecting cable into the AIF
interface on the motec. Diagnosis terminal and connecting cable are not included in the
scope of supply.
‚ Connect mains voltage.
Automatic start is possible! The controller is ready for operation after approx. 1 second.
Keypad:
dc
ƒ Select setpoint via the j
function.
Activate j g w j
CW rotation z c goes off. The drive is running now.
Display indicates output frequency.
CCW rotation y
Faults during commissioning or operation? ^ chapter 8
0Fig. 0Tab. 0