Lenze E82MVxxx 2Bxxx - Manual (Page 126)

Commissioning
Important controller codes
7
l
126 EDK82MV371 DE/EN/FR 7.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0087 Rated motor
speed
à 300 {1 rpm} 16000 à Device−dependent
C0088 Rated motor
current
à 0.0 0.1 (A) 650.0 à Device−dependent
0.0 ... 2.0 x rated output
current of the controller
C0089 Rated motor
frequency
50 10 {1 Hz} 960
C0090 Rated motor
voltage
à 50 {1 V} 500 à 230 V for 230 V
controllers,
400 V for 400 V
controllers
C0091 Motor cos  а 0.40 {0.1} 1.0 а Device−dependent
C0119
v
Configuratio
n of motor
temperature
monitoring
(PTC input) /
earth fault
detection 0 0 PTC input
inactive Earth fault
detection active l Configure signal
output in C0415
l If several parameter
sets are used,
monitoring has to be
set separately for
every parameter set.
l Deactivate earth fault
detection if the earth
fault detection is
actuated
unintentionally.
l If the earth fault
detection is activated,
the motor starts with
a delay of approx.
40 ms after controller
enable has been set.
1 PTC input active,
TRIP effected
2 PTC input active,
warning effected
3 PTC input
inactive Earth fault
detection inactive
4 PTC input active,
TRIP effected
5 PTC input active,
warning effected
C0140
* Additive
frequency
setpoint
(NSET1−NAD
D) 0.00 −650.00 {0.02
Hz}
650.00 l Selection via j
function of the
keypad or parameter
channel
l Acts additively on the
main setpoint
l Value will be stored
when switching the
mains or removing
the keypad
l C0140 is only
transferred during
parameter set
transfer with GDC
(not with keypad)