Rockwell Automation 284D ArmorStart - Safety Version - User Manual - Manual (Page 199)

Troubleshooting 11-19
Base Module Replacement
(Bulletin 280/281) Installation of Base Module
1) Mount Base Module with four mounting screws.
2) Re-install conduit fittings and wires onto terminal block.
3) Tighten the terminal screws.
4) Install terminal cover plate.
5) Tighten four mounting screws on the terminal access cover plate.
6) Install Control Module.
7) Tighten the four mounting screws.
8) Install motor cable, comunication cables and all others connected
to the inputs and outputs.
Figure 11.4 Bulletin 280/281 Base Module Installation
ATTENTION
!
To avoid shock hazard, disconnect main power
before working on the controller, motor, or control
devices
4
3
1
2
46 - 50 lb-in
7
7
6
5
Base Module
Input/
Output
Cable
Communication
Cable
Motor Cable
Control Module
Terminal Access
Cover Plate
Base
Module
12 lb - in./1.36 Nm