Rockwell Automation 284D ArmorStart - Safety Version - User Manual - Manual (Page 93)

Bulletin 284 Programmable Parameters for Sensorless Vector Controllers 4-23
Control SW Ver
Main Control Board software version for AC Drive. Parameter Number 116
Access Rule GET
Data Type UINT
Group Display Group
Units 0.01
Minimum Value 1.00
Maximum Value 99.99
Default Value Read Only
Drive Type
Used by Rockwell Automation field service personnel. Parameter Number 117
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 1001
Maximum Value 9999
Default Value Read Only
Elapsed Run Time
Accumulated time drive is outputting power. Time is displayed in 10 hour
increments. Parameter Number 118
Access Rule GET
Data Type UINT
Group Display Group
Units 1 = 10 hrs
Minimum Value 0
Maximum Value 9999
Default Value Read Only
Testpoint Data
The present value of the function selected in Parameter 202. Parameter Number 119
Related Parameter 202
Access Rule GET
Data Type UINT
Group Display Group
Units 1 Hex
Minimum Value 0
Maximum Value FFFF
Default Value Read Only
Analog In 0…10V
The percent value of the voltage at I/O terminal 13 (100% = 10V). Parameter Number 120
Related Parameter 210, 211
Access Rule GET
Data Type UINT
Group Display Group
Units 0.1%
Minimum Value 0.0%
Maximum Value 100.0%
Default Value Read Only
Analog In 4…20 mA
This parameter is not available for use with the Bulletin 284 ArmorStart
Distributed Motor Controller.
Parameter Number 121