Rockwell Automation 284D ArmorStart - Safety Version - User Manual - Manual (Page 36)

2-18 Installation and Wiring
Optional Locking Clip The clam shell design clips over the ArmorStart motor connector and
motor cable to limit customer access from disconnecting the motor
cable on the ArmorStart Distributed Motor Controller. The locking
clip is an optional device that can be used, if desired.
Figure 2.4 Bulletin 280 Installation of Locking Clip
Figure 2.5 Bulletin 281Installation of Locking Clip
Figure 2.6 Bulletin 284 Installation of Locking Clip