Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 169)

Rockwell Automation Publication 1715-UM001C-EN-P - March 2014 169
Configure the Redundant I/O System Chapter 5
11. Click the Network tab.
The Network tab appears.
12. Click OK.
Port Diagnostics Use the Port Diagnostics tab to view diagnostic information for the port. Various communications diagnostic information is available. For each physical
Ethernet Port this includes: link status, duplex setting, speed and auto-negotiation status, and CIP diagnostic information.
Refresh communication This link appears when communication with the module has failed. Click Refresh communication to attempt to restart communication with the module.
Set After you make modifications to the port’s Auto-Negotiate state, Selected Speed, or Selected Duplex configuration values, a reset module message
displays if the module needs to be reset before the modifications take effect. Clicking reset module initiates a reset operation on the module, which returns
the module to its power-up state by emulating the cycling of power.
The Reset Operation also causes the changes made to Auto-Negotiate, Selected Speed, and Selected Duplex to become the port’s current settings.
Table 28 - Port Configuration Parameters
Parameters Description
Table 29 - Network Parameters
Parameters Description
Network Topology Displays the current network topology as either:
• Linear/Star, or
• Ring
Network Status Displays the current network status as:
• Normal
• Ring Fault, or
• Unexpected Loop Detected
Refresh communication This link appears when communication with the module has failed. Click Refresh communication to attempt
to restart communication with the module.