Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 174)

174 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
2. Expand the Digital module list, select the 1715-IB16D module, and click
OK.
The General tab appears.
Table 30 - General Parameters for the Digital Input Module in Duplex Mode
Parameters Description
Type Displays the type and description of the module being created (read-only).
Vendor Displays the vendor of the module being created (read-only).
Parent Displays the name of the parent module (read-only).
Name Enter the name of the module.
Description Enter a description for the module here, up to 128 characters. You can use any printable character in this
field. If you exceed the maximum length, the software ignores any extra characters.
Slot A Choose the slot number in which the module resides.
Slot B When your module is configured for duplex, the slot number in which the redundant module resides is
displayed. When configured for duplex, the Slot B field is shown for reference only.
Change Click Change to access the Module Definition dialog box. From the Module Definition dialog box, you
can change the values that define the module definition, Electronic Keying, and Minor Revision.