Rockwell Automation 1771-QC , D17716.5.25 SER/B SERVO POS - Manual (Page 45)

Hardware Description
Chapter 5
5Ć8
Input Supply
You must connect a 5-30V dc power supply between terminals 1 and 12
of the left wiring arm. This provides power for the input circuits. The
input circuits require 500mA (maximum) at 30V. You can use the same
power supply to power the encoder if the power supply has enough
additional current capacity for the encoder.
Drive Disable Supply
Unless the servo drive provides its own dc voltage source for this circuit,
you’ll need a 5 - 30V dc power supply to provide 100mA (maximum) for
the drive disable circuit. How you connect this power supply depends on
whether the servo drive requires a current source or a current sink to
enable it.
Analog Supply
A separate +15V dc supply is needed to provide 200mA (maximum) for
the digital/analog converter (DAC) to generate the analog output signal
and for the hardware done output circuit.
The servo positioning assembly can be used with PC processors that have
block transfer capability and adequate data table size to contain the data
blocks you need for your application. Compatible PC processors include:
Mini-PLC-2/05 (cat. no. 1772-LS,-LSP)
Mini-PLC-2/15 (cat. no. 1772-LV)
PLC-2/20 (cat. no. 1772-LP2)
PLC-2/30 (cat. no. 1772-LP3)
PLC-3 (cat. no 1775-L1,-L2)
Compatible Processors