Rockwell Automation Motion Control PTO Application Building Block - Manual (Page 13)

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 13
Micro800 Controller PTO Axis Setup Chapter 1
Configure the Kinetix 3 Drive
In this section, you configure your personal computer and Series B Kinetix 3 drive with firmware revision 3.005 by using
Connected Components Workbench version 6 or later software. You can find the hardware series identifier on the label
attached to the side of the product.
See Figure 1 and Figure 2 to identify the Series of your Kinetix 3 drive.
Figure 1 - Label of Series B Kinetix 3 Drive - That Is Supported by Connected Components Workbench Version 6 or Later
Figure 2 - Label of a Series A Kinetix 3 Drive - That Is Supported by Ultraware Software Only
To configure a Series A Kinetix 3 drive, refer to Configure a Series A Kinetix 3 Drive in Appendix D .
BULLETIN 2071 Kinetix 3 Component Servo Drive, 400W
CAT. NO. 2071-AP1 SERIES B PN-185999 MAX SHORT CIRCUIT 1000,000A
INSTRUCTION MANUAL 2071-IN001x-EN-P FIRMWARE VER. V03.01
BULLETIN 2071 Kinetix 3 Component Servo Drive, 1.1A
CAT. NO. 2071-AP1 SERIES A
MAX SHORT CIRCUIT 1000,000A
INSTRUCTION MANUAL 2071-IN001x-EN-P FIRMWARE VER. V02.00