Rockwell Automation Motion Control PTO Application Building Block User Manual
Page 23
Advertising
Rockwell Automation Publication CC-QS033A-EN-P - February 2014
23
Micro800 Controller PTO Axis Setup Chapter 1
6. Follow these steps to configure the Digital Inputs.
a. Click Next to highlight Digital Inputs.
b. From Input 2 pull-down menu, choose Fault Reset.
7. Follow these steps to configure the Digital Outputs.
a. Click Next to highlight Digital Outputs.
b. From Output 1 pull-down menu, choose Ready.
8. Click Next.
9. Click Finish.
10. Save the project.
11. Click the Disconnect icon.
12. Upload the online values to project file.
13. Change the Drive Address (Pr0.07) to 1 by using the keypad interface.
Advertising