Rockwell Automation Motion Control PTO Application Building Block - Manual (Page 39)

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 39
System Validation Chapter 2
3. Edit the communication settings to your needs.
Connect Your Devices
1. Connect the PanelView Component terminal to your controller's embedded serial port by using a 1761-CBL-PM02
cable.
2. Connect your Kinetix 3 drive's IEEE1394 plug to your Micro800 controller's isolated serial port (2080-
SERIALISOL) by using a modified 2090-CCMDSDS-48AA01 cable.
1761-CBL-PM02