Rockwell Automation Motion Control PTO Application Building Block - Manual (Page 76)

76 Rockwell Automation Publication CC-QS033A-EN-P - February 2014
Appendix C Motion Axis Setup for PTO Building Block
The output terminal for each Drive Reset Output is assigned in each ladder program. The assignment is on the third
branch of rung 1 for each of the PTO building block ladder diagrams
Figure 15 - Sample of a PTO Building Block Ladder Diagram
General
1. Type your axis name in the Axis Name field.
A system variable is created for the name entered in the Axis Name field. The name of the motion axis created in the
starting project downloaded from the sample code website is Axis_01.