Rockwell Automation Motion Control PTO Application Building Block - Manual (Page 37)

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 37
System Validation Chapter 2
Configure PanelView Component Terminal Communication Settings
In the default project, the communication and controller settings have already been configured. Here are the default
settings.
Table 5 - Driver Configuration
Table 6 - Controller Settings
Follow these steps to modify the settings in your Connected Components Workbench project.
1. From the Project Organizer, double-click the PanelView Component terminal icon.
The Design Station is launched.
Parameter Setting
Protocol Serial CIP
Port RS232
Baud Rate 38400
Parity None
Stop Bits 1
Flow Control None
Report Errors FASLE
Station Address 0
Protocol Full Duplex
Accept responses for station address only FASLE
Parameter Setting
Name PLC-1
Controller Type Micro800
Address 1