Rockwell Automation Motion Control PTO Application Building Block - Manual (Page 17)

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 17
Micro800 Controller PTO Axis Setup Chapter 1
14. Configure the driver settings.
a. From the Comm Port pull-down menu, choose the port number of your 1203-USB serial adapter.
b. From the Device pull-down menu, choose PLC-CH0.
c. From the Baud Rate pull-down menu, choose 115200 baud rate.
d. From the Error Checking pull-down menu, choose CRC.
15. Click OK.
16. In the RSLinx tool bar, click the RSWho icon to verify that your drive is properly communicating with RSLinx
Classic software.
IMPORTANT Do not click auto-configure.
a b
c
d