Welch Allyn 1500 Patient Monitor v.1.4.X - User Manual - Manual (Page 17)

Directions for use Introduction 13
Setup menu overview
Press to enter the setup menu and adjust the following settings and options:
Note The following is an overview of the setup menu options. Further details are given
in section 8 (see
“Settings” on page 111 ).
Parameter Settings/Submenus
Alarm Suspend Silences all alarms for a set period. The silence time is defined in the
Administrator menu (alarms).
Arrhythmia
1
Arrhythmia limits and alarm levels.
Pacer Display and analysis (on/off).
Alarms Alarm overview. All alarm limits and print on alarm settings.
Speaker Volume Speaker volume.
HR/PR Tone Volume Heart beat volume.
Waveform area Defines the waveforms to be displayed and the size and sweep speed.
Recorder
2
Defines the data on the printout.
Parameters 3 Enable/disable any combination of the following: ST measurements, etCO
2
,
Masimo SpO2 settings, cardiac output, invasive blood pressure display and
temperature display options.
12-lead Resting ECG 4 View electrode status, and take a resting ECG. After the resting ECG has been
taken, the option to obtain a printout is given.
Hemodynamic
Calculations
5
Screen for entry of hemodynamic measurement parameters with automatic
hemodynamic calculations based on entered parameters.
Drug Calculations Screen for entry of drug parameters with dose and titration calculations based
on entered parameters.
Patient Information 6 Enter/edit patient ID and patient information.
Patient Mode Neonatal:
Birth through 28 days.
Pediatric:
Between 29 days and 12 years.
Adult:
13 years and older.
Restore User Defaults Reset all settings to user defaults (see administrator > system, below).