Monitoring and measurements, General, 5 - monitoring and measurements – Welch Allyn 1500 Patient Monitor v.1.4.X - User Manual User Manual
Page 43
5
39
Monitoring and Measurements
General
•
Connect the ECG electrodes, the NIBP cuff, the SpO
2
sensor, the CO
2
sensor, and
the temperature sensor to the patient as required.
•
As soon as the sensors are connected, the corresponding indication appears on the
display.
•
Check or set the alarm limits (see
Caution
The guidelines in this section are given as an overview only. They are
not a substitute for, nor do they overrule manufacturer documentation and
instructions or departmental procedures.
Note
Values are only displayed when the ECG cable or at least one sensor is
connected. If a sensor is disconnected, a technical alarm is issued. The measured
value will no longer be displayed if the sensor is disconnected and the alarm is
acknowledged.
Note
This section gives a general overview of the parameters that can be measured
with the monitor. It is aimed at medical professionals and no specific medical
direction is given or implied; any instructions given here do not overrule local
medical directives.
The individual parameter menu settings are selected with the trim knob,
described previously (see
“Settings via a parameter field”
).