Initial settings – Welch Allyn 1500 Patient Monitor v.1.4.X - User Manual User Manual
Page 24
20
Operation
Welch Allyn 1500 Patient Monitor
Initial settings
Alarm and general settings are given in the setup menu. Initial monitor settings may
include general alarm settings (alarm silence time, alarm delay time, etc.), and general
monitor settings (height and weight units, time and date, etc.).
Access the setup as follows:
1.
Press the Setup button
.
2. Use the trim knob to select parameters and change values. Press to confirm the
selection and settings.
•
The alarm settings are given in the setup menu: Administrator > Alarm
•
The system settings are given in the setup menu: Administrator > System
Caution
Only authorized personnel, trained in the operation of this monitor, are
qualified to do the setups in the following menu.
Note
The alarm and the system sub-menu are password protected. The password for
both of these is 49, 48, 46.
Note
Details of the setup menu and the passwords are given in the settings section
(see