Y s i, Sonde to computer you will need, Environmental – YSI ADV6600 User Manual
Page 23: 3.4. attaching the cable
Section 2. Preparation of the Sonde
ADV6600
Y S I
Environmental
Page 13
2-3.4. Attaching the Cable
Attach your ADV6600 to a computer for initial setup by connecting the proper end of the cable to
the sonde connector and attaching the strain relief connector to the sonde bail. Then connect the
other end of the cable assembly (DB-9) to a serial port on your computer. Use the diagram and
picture below to make sure that your connections are correct.
Now that the Water Quality sensors, power source, and cable have been installed on your
ADV6600, you are ready to proceed to installation of ADVantage 6600 PC software and the setup
of the firmware which resides within the sonde. These activities are detailed in Section 3.
Sonde to Computer
You will need...
❑ Sonde
❑ Field Cable
❑ Computer with Com Port
❑ 6095B MS-8/DB-9 Adapter
❑ 605389 Power Supply *
Not required if you use
sonde battery
*
DB-9
Power Supply*
Adapter
6095B
Field Cable
MS-8
Sonde
YS
I
69
20
YS
I
69
20
+
+
-
-