Y s i – YSI ADV6600 User Manual
Page 32
Section 3. Installation and Setup
ADV6600
Y S I
Environmental
Page 22
The asterisks (*) that follow the numbers or letters indicate that the parameter will appear on all
outputs and reports. To turn a parameter on or off, type the number or letter that corresponds to the
parameter.
For parameters with multiple unit options such as temperature, conductivity, specific conductance,
resistivity and TDS, a submenu will appear as shown, allowing selection of desired units for this
parameter.
After configuring your instrument with the desired parameters, press Esc or 0 to return to the Main
menu.
Please note the following:
• Even if all of the Water Quality sensors available on the ADV6600 are enabled, the
measurements for those sensors will not appear on your display unless the parameter is
selected in Report setup.
• Only the exact Report parameters and their selected units as selected in Report will be
logged to internal memory during logging studies and you will NOT be able to obtain