Connecting to the system, 9. adv6600 firmware upgrades, Section 4 – YSI ADV6600 User Manual
Page 26: Calibration and diagnostics, Y s i, 4. connecting to the system
Section 3. Installation and Setup
ADV6600
Y S I
Environmental
Page 16
3-4. Connecting to the System
When choosing the “Connect to System” selection, the Open New Session dialog box will appear
as shown below. A Session is used to describe a mode in which the software will be utilized. The
type of session may be selected by clicking on the appropriate button.
The default settings in the dialog box establish a Serial Connection which allows direct connection
between the ADV6600 and your computer
through a serial (COM) port. This option
should be used for most ADV6600
applications. You will need to select the
COM port to which your ADV6600 is
attached and confirm that the baud rate is set
to 9600.
Settings
This area displays the available COM ports on
your computer and the COM port being used