ADLINK IMB-S90 - Manual (Page 59)

IMB-S90 IPMI User’s Manual
59
Destination Type: Destination type can be either an SNMP Trap or an Email alert. For
Email alerts, the 3 fields - destination Email address, subject and body of the message
needs to be filled. The SMTP server information also has to be added - under
Configuration->SMTP. For SNMP Trap, only the destination IP address has to be filled.
Destination Address: If Destination type is SNMP Trap, then enter the IP address of the
system that will receive the alert. Destination address will support the following:
• IPv4 address format.
• IPv6 address format.
Subject & Message: These fields must be configured if email alert is chosen as
destination type. An email will be sent to the configured email address in case of any
severity events with a subject specified in subject field and will contain the message field’s
content as the email body.
Send Test Alert: To send sample alert to configured destination.
Note: Test alert can sent only with enabled SMTP configuration. SMTP support can be
enabled under Configuration->SMTP.
Add: To add a new entry to the device. Alternatively, double click on a free slot.
Modify: To modify that entry. Alternatively, double click on the configured slot.
Delete: To delete the selected configured LAN Destination.
3.7.14.3.1 Procedure:
1. In the LAN Destination Tab, choose the slot to be configured. This should be the
same slot that you have selected in the Alert Policy Entry- Destination Selector field.
That is if you have chosen the Destination Selector as 4 in the Alert Policy Entry
page of Alert Policy Tab, then you have to configure the 4
th
slot of LAN Destination
Page.
2. Select the slot and click Add or alternatively double click on the empty slot. This
opens the Add LAN Destination entry.
Add LAN Destination entry Page
3. In the LAN Destination field, the destination for the newly configured entry is
displayed and this is a read only field.