ADLINK IMB-S90 - Manual (Page 77)

IMB-S90 IPMI User’s Manual
77
3.7.20.1 Procedure
1. In the System Log field, enable or disable the option.
2. Select the Log type: Local Log or Remote Log.
3. If Local log is selected, enter the file size in the File Size field and rotate count in
the Rotate Count field.
Note: If Remote log is selected, the fields file size and rotate count need not be
mentioned.
4. If remote log is selected specify the Server Address of the remote server, where
the system events are logged.
5. In the Audit Log field, check or uncheck the Enable option as desired.
6. Click Save to save the changes.
7. Click Reset to reset the entries.
3.7.20.2 Steps to configure the remote server to enable syslogging
Note: This example uses FC13 as the remote machine to log syslog.
On FC machine, disable the following lines for UDP in /etc/rsyslog.conf.
1. MODLOAD imudp
2. UDPSERVER 514
3.7.21 System Firewall
In MegaRAC GUI, the System Firewall page allows you to configure the firewall settings.
The firewall can be set for a range or IP Addresses or Port Addresses. To view this page,
you must at least be an operator. Only administrators can add or delete a firewall.
To open System Firewall page, click Configuration > System Firewall from the menu
bar.
3.7.21.1 Advanced Settings
1. Click on the Advanced Settings button. This opens the Advanced Firewall Settings
window as shown below.
Advanced Firewall Settings