Xtramus APMPT-4 V2.4 - Manual (Page 114)

114
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
To assign Active Ports as the Member Ports for
Root 1 or Root 2, please click the Active Ports
you would like to use as Member Ports, and then
click the  button to add it to the member Ports
field located on the right side. To remove a
Member Port you‟ve assigned, click the Member
Port you would like to remove, and then click the
 button.
 Available Ports: All available Active Ports
will be shown in this field. If you assign an Active Port as the Root Port or one of the Member Ports,
it will be removed from this field.
 /: You can add an selected Active Port as the Root Port or one of the Member Ports by
clicking the  button, or remove the Root Port or Member Ports by clicking the  button.

Reset: Click this button to remove all Active Ports that has been assigned as Root Port or
Member Ports.
 Enable Root 1/2: Click these check boxes to select which Root you would like to use for 1 to
Many-UC test.
 Root 1/Root2: Click these tabs to choose which Root you would like to view/configure.